The Atelier
Made slowly,
by hand
Our pieces are produced in small runs by leather artisans, using the same construction language as fine handbags.
I
Selection
Hides are chosen by hand for grain consistency, then rested before cutting.
II
Cutting
Each panel is cut to the device, with allowance for raised screen and camera edges.
III
Stitching
Edge stitching in matched thread, then burnished and sealed by hand.
IV
Finishing
Hardware set, monogram struck, and the piece boxed in espresso and cream.
Shielded Technology
Designed with a protective material layer
Selected cases include a shielding layer intended to reduce exposure to RF energy under specified conditions. We describe what was measured, how it was measured, and the conditions it applies to. We make no health or medical claims.
What is measured
Attenuation of RF energy through the shielding layer across specified frequency bands.
How it is measured
Laboratory bench testing of the material layer using a signal source and calibrated receiver.
Conditions
Results apply to the tested material, orientation and distance only, and vary in real-world use.
Full methodology and measurement tables are published per collection. Where a case has not been tested, we say so rather than implying a specification.
Packaging
Made to be yours
An espresso rigid box with a cream interior, a blind-embossed mark, and a single card. The case sits inside as a luxury accessory, not a phone part.
Personalize yours